Makita DCS 43 Instrukcja Obsługi Strona 1

Continuous Rating (W)Voltage (V) Cycle (Hz)Input OutputMax. Output (W)740Models No. DescriptionNEW TOOLCurrent (A)TECHNICAL INFORMATIONCONCEPT AND MAI

3-10. Disassembling/Assembling Carburetor (cont.)10/ 201) Remove Diaphragm cover and Diaphragm gasket set by unscrewing four Pan head screws. No

3-10. Disassembling/Assembling Carburetor (cont.)11/ 20 7) Before removing two Pan head screws, tighten the idling screw on (A) to the full. (Fig. 38)

12/ 20 3-13. Routing Tubes1) Route Tubes as illustrated in Fig. 44.2) Install Gasoline filter on the end of the fuel suction tube, which will be

13/ 20 Fig. 52 Fig. 533-14. Removing/Disassembling/Assembling Engine Block (cont.)1) Separate Crank case from Cylinder by removing four M5x20 Hex s

14/ 20 3-14. Removing/Disassembling/Assembling Engine Block (cont.)1) Assemble Piston so that the triangular marking on its top is placed on the ex

15/ 20 3-15. Disassembling/Assembling Kickback Brake System1) Release Brake band (Hand guard cover) by pulling Front hand guard as illustrated in F

16/ 20 3-16. Miscellaneous Remarks[1] Do not reuse Gaskets between Exhaust muffler and Cylinder. Always use new one for replacement. (Fig. 66)4.

Circuit diagramP 17/ 20 SwitchIgnition coil completeInsulated connectorBody earthReceptacleColor index of lead wires' sheathBlackRedInsulated rec

P 18/ 20 SwitchReceptacleLead wire (black)Lead wire (red)Wiring diagramTop handle coverConnect the lead wires (red, black)with the terminals of switch

P 19/ 20 Lead wiresWiring diagramTop handle coverRoute the lead wires throughthe space (the shaded portion)between the main housing andthe top cover.T

[II] Disassembly/Assembly/Adjustment1. Necessary Repairing Tools2. Lubrication/SealingAfter you have disassembled the following parts, do lubrication

P 20/ 20 Lead wireWiring diagramBaffle plateRoute the lead wire throughthe space (the shaded portion)between the main housing andthe baffle plate.Main

1) Clutch can be easily removed using Impact driver without locking Spindle.2) Do not remove Spark plug because Clutch is removed using compression re

3-3. Oil Pump Section (cont.)3-4. Adjusting the Flow of Chain OilFig. 10Fig. 114 / 20 The flow of chain oil can be adjusted by turning the adjusting s

3-5. Ignition System (cont.)5 / 20 3-7. Inspection/Replacement of Stop Switch1) Remove Plug cap, and remove Spark plug with supplied Wrench 13-16.

3-7. Inspection/Replacement of Stop Switch (cont.)6 / 20 3) Using circuit tester, also check the conduction between the engine block and the termin

3-9. Replacement of Recoil Starter Rope7 / 20 Fig. 22Fig. 23Fig. 25Fig. 241) Remove Side handle, and separate Recoil starter assembly from the mach

3-9. Replacement of Recoil Starter Rope (cont.)8 / 20 4) Connect Reel with Spiral spring by turning clockwise while tilting it as illustrated in

3-9. Replacement of Recoil Starter Rope (cont.)9 / 20 1) Fix the straight end of Spiral spring in the small hole on Spring case as illustrated in F