Makita DCS232T Instrukcja Obsługi Pobierz pdf (Strona 16)

Electrode gap

The electrode gap must be 0.6 – 0.7 mm.

Cleaning the inlet port of the cooling air

Unscrew four screws (2). Remove recoil starter (3).

Clean the inlet port (4) and the cylinder fins.

Cleaning the muffler

CAUTION: If the engine is hot there is a risk of burning. Wear protective gloves.

Remove the sprocket cover (see “PUTTING INTO OPERATION”).

Remove deposits of carbon from the exhaust outlets (11) of the muffler.

Cleaning the cylinder space

Remove the sprocket cover (see “PUTTING INTO OPERATION”).

If necessary remove muffler by loosening and removing the two screws (14).

Stuff a rag into the cylinder port (15).

Use a suitable tool (wooden scraper) to clean out the cylinder space (16), especially the cooling

fins.

Remove the rag from the cylinder port and refit the muffler according to the diagram.

Replace the gasket (13) if necessary. Carefully remove any pieces of the old gasket from the muf-

fler.

Ensure correct mounting position. The cowling should follow the contour of the cylinder to

ensure correct heat transfer.

Tighten screws (14) to 10 Nm while the engine is cold.

0.6 – 0.7 mm

STOP

1 2 ... 11 12 13 14 15 16 17 18 19 20

Brak uwag

Modelli	Tipo di Documento
BW1428	Manuale Utente BENDIX BW1428 User's Manual, 8 pagine
SD-03-818	Manuale Utente BENDIX SD-03-818 User's Manual, 8 pagine
SD-13-4788	Manuale Utente BENDIX SD-13-4788 User's Manual, 32 pagine
C-300N HYDRAULIC POWER STEERING	Specifiche BENDIX C-300N HYDRAULIC POWER STEERING Specifications, 16 pagine

Makita DCS232T Instrukcja Obsługi Strona 16