Makita UC4051A Instrukcja Obsługi Pobierz pdf (Strona 12)

1. Loosen the sprocket cover lightly.

2. Lift up the guide bar tip slightly.

3. Turn the adjusting screw / dial to adjust saw chain

tension.

014680

014682

4. Tighten the saw chain until the lower side of the

saw chain fits in the guide bar rail (see circle).

5. Keep holding the guide bar lightly, tighten the

sprocket cover after adjusting the chain tension.

Make sure that the saw chain does not loose at

lower side.

Make sure the saw chain fits snugly against the lower

side of the bar.

CAUTION:

• Do not tighten the saw chain too much.

Excessively high tension of saw chain may cause

breakage of saw chain, wear of the guide bar and

breakage of the adjusting dial.

• A chain which is too loose can jump off the bar,

and therefore presents an accident risk.

• Carry out the procedure of installing or removing

saw chain in a clean place free from sawdust and

the like.

Engaging extension cord

CAUTION:

• Make sure that the extension cord is unplugged to

the mains outlet.

014359

When engaging the extension cord, secure it to the

chain saw's cord with the cord hook.

Attach the cord hook about 100 - 200 mm from the

extension cord connector. This helps prevent

unintentional disconnection.

OPERATION

CAUTION:

• Hold the tool firmly with right hand on the rear

handle and left hand on the front handle when

performing the tool.

Switch action

014376

CAUTION:

• Always be sure that the tool is switched off and

unplugged before checking function on the switch

trigger.

• Before plugging in the tool, always check to see

that the switch trigger actuates properly and

returns to the "OFF" position when released.

To prevent the switch trigger from being accidentally

pulled, a lock-off button is provided.

To start the tool, depress the lock-off button and pull the

switch trigger. Release the switch trigger to stop.

Lubrication

CAUTION:

• Always be sure that the tool is switched off and

unplugged before lubricating the saw chain.

1. Loosen

2. Tighten

3. Adjusting dial

4. Guide bar

5. Saw chain

1. Loosen

2. Tighten

3. Chain adjusting

screw

4. Guide bar

5. Saw chain

1. Lock-off button

2. Switch trigger

1. Cord hook

2. Tool's cord

3. Extension cord

4. Plug and socket

(the shape may

differ from country

to country)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Makita UC4051A Instrukcja Obsługi Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piły łańcuchowe Makita UC4051A